Wright Airplanes

  Home    History Wing    Adventure Wing    Exhibits & Programs    Company Store    Information Desk



Entrance 

Information Desk 

Just the Facts  

   Up       

The Wright    
Family
 

Wright Bicycles 

   Wright Kites    
and Gliders 

    Wright    
airplanes
  
(You are here.)        

Wright Engines    
And Propellers 

Wright Trivia 

Down        

Wright Flyer I 

Wright Flyer II 

Wright Flyer III 

Model A 

Military Flyer 

Transitional    
Model AB
 

Model B 

Model R 

Model EX 

Model C 

Model D 

Model CH 

Model E 

Model G 

Model L 

             

Need to    

find your    

 bearings?    

Try these    
navigation aids:    

 Site Map 

Museum Index 

Search    
the Museum
 

 If this is your first    
visit, please stop by:   

About    
the Museum
 

Something to share?   
 Please:   

Contact Us 

            

  Available in Française, Español, Português, Deutsch, Россию, 中文, 日本, and others.

1903 Flyer I -- The Wright Brothers first powered aircraft, and the first in which anyone made a sustained, controlled flight. As in their earlier gliders, it had a variable-camber twin canard in front to control pitch and a twin rudder in back to control yaw. Roll was controlled by warping the wings.
 


Orville checks the Flyer I as it rests on the launching rail on the sands near Kitty Hawk, NC..

The first flight of December 17, 1903.
1904 Flyer II -- The Wright Brother second powered aircraft, almost a copy of the Flyer 1, with which they learned they still had a lot of work to do before they had a practical airplane. It was also the first aircraft on which the Wrights used their distinctive "bent-end" propellers.
 

Wilbur and Orville in discussion with the Flyer II and its hangar in the background.

The Flyer II flying over Huffman Prairie on November 16, 1904.
1905 Flyer III -- The Wright's 1905 aircraft, their third powered machine, was the world's first practical aircraft. Both the canard and the rudder were extended out from the aircraft to make it easier to control. Semi-circular "blinkers" between the surfaces of the canard prevent the nose from dropping in a turn.
 

The Flyer III being launched by catapult (the tall tower to the right) in June of 1905.

The Flyer III during one of its public flights on October 4, 1905.
1907-1909 Wright Model A -- This was the aircraft that convinced the world that the Wrights had indeed flown. It was also the first two-seat aircraft, and the first Wright aircraft in which the occupants sat upright.
 

A Model A on the launching rail with the catapult cocked in the spring of 1909.

A Model A rounds a pylon at the air races in Rheims, France in 1909.
1909 Military Flyer -- Slightly smaller and faster that the Model A, the Wrights sold this aircraft to the United States Army Signal Corp to become the first military aircraft.
 

Orville discusses the next flight with Lt. Frank Lahm in front of the Military Flyer.

Wilbur watches Orville demonstrate the Military Flyer at Fort Myer, VA in 1909.
1909-1910 Wright "Transitional" Model A -- Sometimes called the Model A-B, this was the first airplane that the Wrights built with an elevator in the back. However, they retained the canard in front, using both surfaces to control the pitch of the aircraft.
 

The Wrights test an aircraft with an elevator in the front and the back.

The Wrights trained their exhibition students to fly on a Model AB at their flight school in Montgomery, AL.
1910-1914 Model B -- Built by the newly formed Wright Company, this was the first mass-produced airplane.  It was also the first Wright airplane  without a canard. It had a single elevator in the back, just behind an enlarged twin rudder. Triangular blinkers were mounted on the forward skid struts. The airplane rested on wheels, dispensing with the need to launch the aircraft from a rail. Like all previous Wright aircraft, it used wing warping to control roll.
 

A Wright Model B rolling off the assembly line at the Wright Factory in Dayton, OH.

Charles Atwood takes off from a beach in his Model B.
1910  Wright Model R  -- Also called the "Roadster" and the "Baby Wright," this small single-seat aircraft was built for racing. It had either a 6- or 8-cylinder motor and could achieve speeds of 70 to 80 miles per hour.
 

A close-up of the V-8 engine that powered the Model R.

The Model R ready to launch.
1911-1912  Wright Model EX --  Built especially for exhibition flight, this aircraft had a shorter wing span than other models, which gave the exhibition pilots more speed. It also had a single seat, which prevented them from taking passengers. This was a follow-on to the Model R, using  longer wings and a standard Wright 4-cylinder motor. This was the first aircraft to be flown across a continent.
 

The Wright Model EX "Vin Fiz" just before it began it's transcontinental flight from Sheepshead Bay, NY to Long Beach, CA.

A Wright Model EX turning round a pylon at an exhibition flight in Mineola, NY.
1912-1913 Wright Model C  -- This aircraft replaced the Model B as the standard Wright Aircraft. It had slightly flatter wings and a  taller rudder for improved directional control. The blinkers became rectangular vanes attached to the front end of the skids. It came standard with a Wright 6-cylinder motor.

A Wright Model C on the factory floor. Note that the rudder now rises above the top outriggers that hold the tail.

Orville flew a Model C to demonstrate his "automatic stabilizer," the first autopilot.
1912 Wright Model D  -- This was a light, fast single-seat aircraft that the Wright built in response to the U.S. Army's request for a "speed scout." It's 6-cylinder engine and short wing span  gave it a top speed of 66 miles per hour.
 

The Wright Model D on the ground at Simms Station (Huffman Prairie).

The Wright Model D during a demonstration flight.
1913 Wright Model CH  -- This was the first Wright hydroplane, a Model C on a single wide pontoon. Later versions had two slender "stepped" pontoons. The tail was supported by a smaller float mounted under the rudder.
 

An early Model CH at anchor on the Great Miami River.

A later Model CH with stepped pontoons. The steps helped the aircraft "break the surface" of the water.
1913 Wright Model E  -- A one-seat exhibition machine, this was the first Wright aircraft with a single propeller. The tail booms were attached further out on the wings to make room for the 7-foot chain-driven propeller.
 

The Wright Model E was intended as an exhibition aircraft – it could be set up and ready to fly in under an hour.

A Model E over Simms Station.
1913 Wright Model F  -- The Model F marked a radical departure in design for the Wright Company. They dispensed with blinkers and curtains and added a fuselage. They moved the motor forward of the wings, created a semi-standard tail by resting the rudders atop the elevator, and hinged the elevator.
 

A drive shaft ran from the engine in the nose between the seats to the chain drive.

The Model F had a pronounced wing dihedral to increase lateral stability.
1913-1914 Wright Model G -- Designed by Grover Loening under the supervision of Orville Wright, this was the only flying boat built by the Wright Company. In production models, the elevator was placed atop the rudder to create a "T-tail."
 

An experimental version of the Model G makes a take-off run from the Great Miami River near Dayton, OH.

The Wright Model G on approach for a landing.
1914-1915 Wright Models H & HS -- These two aircraft were very similar to the Model F, but the fuselage was streamlined so that it tapered back to the tail. The HS had a short wingspan, just 32 feet (9.75 meters) to give it more speed and increased rate of climb. The H had longer wings for an increased payload. This was the last Wright "pusher" and the last with a double rudder.
 

The Wright Model HS at Simms Station. Note the wheel spokes have been covered with plates. This decreased drag.

With its long wings, the Model H could carry over 1000 lbs (454 kg).
1915 Wright Model K -- This was a seaplane, manufactured for the United States Navy. The Model K was Wright Company's first tractor airplane with the propellers facing forward. It was also the first Wright aircraft to use ailerons. And it was the last to use the distinctive Wright "bent-end" propellers, designed nearly ten years previously.

The Model K rest on its pontoons in the Wright factory.

The Model K taxies in the ocean water prior to take-off.
1916 Wright Model L --The Model L was a single place airplane, designed to fill the U.S. Army's request for a light, fast scouting machine.  This was the last aircraft manufactured by the Wright Company. Orville had sold the company by this time, but he may have had some small influence on the design since he was retained as a consultant for a short time after the sale.
 

The Wright Model L used the same standard control surfaces as the Model K.

The Model L did away with the chain drive. There was a single propeller mounted directly to the engine.
Note: The Wright Company never made a Model I or a Model J. These were made by the Burgess Company which licensed Wright patents. In a letter to the Secretary of War dated 22 January 1914, Orville Wright claimed that the Burgess models infringed on these patents. Burgess was licensed to build only exact copies of Wright aircraft and the Burgess Models I and J, while based on Wright designs, incorporated other features.
 

Back to the top

  Home    History Wing    Adventure Wing    Exhibits & Programs    Company Store    Information Desk

"Aviation is proof that – given the will – we can do the impossible."
 Eddie Rickenbacker

 

 

The Wright Story/An Unusual Childhood/A Life on Hold

Part of a biography of the Wright Brothers

www.wright-brothers.org
Copyright © 1999-2010